# Design Sprint II - "Motorin"

**URL:** <https://forums.kinograph.cc/t/design-sprint-ii-motorin/1744>\
**Category:** Uncategorized\
**Created:** [May 8, 2020, 1:25pm UTC](https://forums.kinograph.cc/t/design-sprint-ii-motorin/1744 "2020-05-08T13:25:02Z")\
**Posts on this page:** 1\
**Showing post:** 5

<div class="post-metadata">

**Author:** ![Greg](https://forums.kinograph.cc/letter_avatar_proxy/v4/letter/g/71c47a/32.png) [@Greg](https://forums.kinograph.cc/u/Greg)\
**Post date:** [May 10, 2020, 10:47pm UTC](https://forums.kinograph.cc/t/design-sprint-ii-motorin/1744/5 "2020-05-10T22:47:14Z")

</div>

I am using DC motors and I am not using any mechanical tension control. The speed of a DC motor is proportional to its voltage. The torque of a DC motor is proportional to its current draw. The current draw of a DC motor can easily be determined via a low ohm sense resistor and an op amp. The current signal is input to your controller and can serve as the input to a PID controller implemented in software. To close the loop, the PID output to the motor is a PWM signal. Since the film is unwinding from a reel of known size, you can adjust the torque based on the calculated leverage of the unwinding film to the center of the reel. I believe this is a very simple and reliable way to maintain constant tension thereby avoiding mechanical dancers and such.

---

_[View the full topic](https://forums.kinograph.cc/t/design-sprint-ii-motorin/1744)._
